Start Over Date 1945 Collection IUL Moving Image Archive Unit IUL Moving Image Archive

31. Peace comes to America (10:46)

Date:
1945
Main contributors:
Truman, Harry S., 1884-1972
Summary:
Asserts that although World War II is over, Americans still have responsibility for their government and veterans of the war. Features appearances by President Harry S. Truman, Secretary of the Tre...

32. Perishable rush (13:48)

Date:
1945
Main contributors:
United States. Army Air Forces.
Summary:
Shows how the Army Air Forces during World War II flew wounded men from Pacific battle areas to hospitals and home towns in the United States. Uses a mix of actuality footage and fictional reenactm...

34. Repulsion induction motor general overhaul (24:52)

Date:
1945
Summary:
Shows how to check a repulsion-induction motor for electrical and mechanical faults; how to dismantle a repulsion-induction motor; how to clean and plug the commutator; how to turn the commutator; ...

35. Roughing-in non-metallic sheathed cable (24:02)

Date:
1945
Summary:
Shows how to plan the installation of the circuit run, switch run, and wall receptacle run; how to determine the location of required runs; how to install an offset bar hanger and ceiling outlet bo...

36. Sawing a reverse curve and a bevel reverse curve (17:25)

Date:
1945
Summary:
Shows how to select and lay out stock to avoid waste; how to reverse curves to contour lines; how to use the table tilting gage; how to saw a bevel reverse curve; how to prepare a template for a ne...

37. Secrets (07:11)

Date:
1945
Main contributors:
United States. Navy Department
Summary:
Discusses the importance of various secret weapons used throughout World War II, such as radar and the atomic bomb. The film emphasizes the development and use of these weapons as being critical to...

38. Setting up and machining bar stock (34:09)

Date:
1945
Summary:
Shows how to set up the turret lathe for the production machining of bushings from bar stock; how to install the collet; how to set up the hexagon turret; and how to set up the cross slide.

39. Setup for face milling with a fixture (20:09)

Date:
1945
Summary:
Shows how the horizontal boring, drilling, and milling machine operates; how to install the fixture; how to set up the workpiece; and how to select and install an end mill and a face mill.

40. Sharpening and tempering farm tools (16:07)

Date:
1945
Summary:
Shows how to heat carbon-steel tools for forge sharpening; how to sharpen, harden, and temper a plowshare; how to sharpen, harden, and temper a cultivator shovel; and how to identify tempering colors.